DTC Charts

WARNING: This page is about a different car, the 2011 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Network DTCs (U-codes) are often a result of intermittent concerns such as damaged wiring or low battery voltage occurrences. Additionally, vehicle repair procedures such as module reprogramming often set network DTCs. Replacing a module to resolve a network DTC is unlikely to resolve the concern. To prevent repeat network DTC concerns, inspect all network wiring, especially connectors. Test the vehicle battery, refer to BATTERY, BATTERY MOUNTING & BATTERY CABLES article.

NOTE: Refer to DESCRIPTION AND OPERATION , Intelligent Access (IA) with Push Button Start in ANTI-THEFT SYSTEM - PERIMETER to review the procedures for achieving the various ignition states (ignition off, ignition in accessory, ignition on, ignition start).

NOTE: This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.

COMMUNICATION NETWORK DTC CHART

DTC	Description	Action
U0001:88	High Speed CAN Communication Bus: Bus Off	The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0002:88	High Speed CAN Communication Bus Performance: Bus Off	The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0011:88	Medium Speed CAN Communication Bus Performance: Bus Off	The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0028:08	Vehicle Communication Bus A: Bus Signal/Message Failures	The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0028:88	Vehicle Communication Bus A: Bus Off	The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0073	Control Module Communication Bus A Off	The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U3000:88	Control Module: Bus Off	The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
All network DTCs referenced to this service information from another article.		GO to SYMPTOM CHART .
All other DTCs		REFER to MULTIFUNCTION ELECTRONIC MODULES article.