Body Control Module (BCM): Removal
NOTE:
Prior to the replacement of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new module after installation. For additional information, refer to
MODULE CONFIGURATION
. For vehicles without Intelligent Access (IA), verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
- Upload the module configuration information from the BCM into the scan tool. For additional information, refer to MODULE CONFIGURATION .
- Remove the driver door scuff plate.
- Disconnect the electrical connectors.
- Remove the harness pushpin from the BCM.
- Remove the nut.
- Lower the BCM (release the BCM from the 2 alignment holes).
- Press the black tang inward to release the B+ connector from the BCM.
- Remove the BCM.
NOTE:
This step is necessary only if the BCM is being replaced.