LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 2012 >> MKX AWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> MULTIFUNCTION Electronic Modules >> Removal And Installation >> Remote Function Actuator (RFA) Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Remote Function Actuator (RFA) Module: Installation

  1. Position the RFA module onto the studs and install the 2 nuts.
  2. Connect the RFA module electrical connectors.
    3. NOTE: If the RFA module was not replaced, this is the last step that is necessary.
  3. Install the glove compartment. For additional information, refer to Instrument Panel - Exploded View in INSTRUMENT PANEL AND CONSOLE .
  4. Carry out the parameter reset between the RFA module and the Body Control Module (BCM). For additional information, refer to Passive Anti-Theft System (PATS) Parameter Reset in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
  5. Program the Intelligent Access (IA) keys (minimum of 2) into the new RFA module. For additional information, refer to Key Programming Using Diagnostic Equipment in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
  6. Turn the ignition ON.
  7. Carry out the keyless entry keypad code reset. For additional information, refer to Keyless Entry Keypad Code Programming in HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
  8. Download the RFA module configuration information from the scan tool into the new RFA module. For additional information, refer to MODULE CONFIGURATION .
  9. Carry out the RFA module self-test to confirm all DTCs have been cleared.
scientia non olet · About LEMON Manuals