Removal and Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Vehicles with 8 inch screen
- Remove the Front Display Interface Module (FDIM) refer to FRONT DISPLAY INTERFACE MODULE (FDIM) .
- Disconnect the electrical connectors.
- Remove the 4 screws and remove the Accessory Protocol Interface Module (APIM) from the FDIM
.
- To install, tighten to 0.6 Nm (5 lb-in).
Vehicles with 4.2 inch screen
- Remove the front floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Remove the floor console rear trim panel.
- Remove the 5 screws and the remove floor console HVAC duct.
- Remove the 3 screws and remove the APIM
from the mounting bracket.
- Disconnect the electrical connectors.
- To install, tighten to 0.6 Nm (5 lb-in).
All vehicles
- To install, reverse the removal procedure.
- If a new APIM is being installed, program the APIM to the correct software level. For additional information, refer to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING - 4.2-INCH (107 MM) SCREEN or ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING - MODULE REPLACEMENT, 8-INCH (203 MM) TOUCHSCREEN .