Removal and Installation
NOTE:
Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.
NOTE:
Do not allow any brake fluid or foreign material to enter the mating side of the Anti-lock Brake System (ABS) module or damage to the solenoids can occur.
- Remove the Hydraulic Control Unit (HCU). For additional information, refer to HYDRAULIC CONTROL UNIT (HCU) - HYBRID .
- Remove the 4 ABS module screws and the ABS module.
- To install, tighten to 2 Nm (18 lb-in) using a cross-type pattern.
- To install, reverse the removal procedure.
NOTE:
Make sure the HCU and ABS module are clean and free of any brake fluid or foreign material before separating the components.
NOTE:
Visually inspect the ABS module terminals for damage before installation.