Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Remove the Air Cleaner (ACL) assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - HYBRID .
Install the Engine Support Bar and support the engine and transaxle.

Fig 1: Supporting Engine Using Engine Support Bar
Courtesy of FORD MOTOR CO.
Disconnect the hood ajar electrical connector.

Fig 2: Locating Hood Ajar Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the bolt and the nut and position aside the Battery Junction Box (BJB).
- To install, tighten to 10 Nm (89 lb-in).
  
  Fig 3: Locating Battery Junction Box Mounting Bolt And Nut
  Courtesy of FORD MOTOR CO.
Remove the 5 nuts and remove the transaxle support insulator and the bracket.
- To install, tighten to 90 Nm (66 lb-ft).
  
  Fig 4: Locating Transaxle Support Insulator Bracket Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.