Cylinder Block Distortion
WARNING: This page is about a different car, the 2013 Ford Focus and 2012 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL(S) / GENERAL EQUIPMENT
| Feeler Gauge |
NOTE:
Refer to the ENGINE - 2.0L DURATEC-HE
or ENGINE - 2.0L ECOBOOST
for the specification.
- Use a Straightedge and a Feeler Gauge Set to inspect the cylinder block for flatness.
General Equipment : Feeler Gauge
NOTE:
Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.