Component Testing Procedure
COMPONENT TESTING PROCEDURE
| Circuit to test | Connect self-powered test light or ohm-meter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Tilt Open | 12 and 6 | Open (push) | Closed circuit |
| 12 and 8 | Open (push) | Open circuit | |
| 12 and 3 | Open (push) | Closed circuit | |
| Tilt Close | 12 and 8 | Close (pull) | Closed circuit |
| 12 and 6 | Close (pull) | Open circuit | |
| 12 and 3 | Close (pull) | Closed circuit | |
| Slide Open | 12 and 6 | Open (push) | Closed circuit |
| 12 and 8 | Open (push) | Open circuit | |
| Slide Close | 12 and 8 | Close (pull) | Closed circuit |
| 12 and 6 | Close (pull) | Open circuit | |
| Vent Open | 12 and 4 | Open (push) | Closed circuit |
| 12 and 9 | Open (push) | Open circuit | |
| Vent Close | 12 and 9 | Close (pull) | Closed circuit |
| 12 and 4 | Close (pull) | Open circuit |