Powertrain Drivetrain Mount Neutralizing

WARNING: This page is about a different car, the 2016 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to the appropriate information and procedure for special instructions on loosening and tightening mount fasteners.

1.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .

2.

Loosen, but do not remove, the powertrain/drivetrain mount fasteners.

3.

Lower the vehicle.

NOTE: Do not twist or strain the powertrain/drivetrain mounts or damage to the mounts may occur.

4.
Start the vehicle and move it in forward 0.6-1.2 m (2-4 ft). Then move the vehicle in reverse the same distance.

5.

Raise and support the vehicle.

6.

Tighten the powertrain/drivetrain mount fasteners.

7.

Lower the vehicle.

8.

Test the system for normal operation.