Main Control Overhaul: Overhaul
- Discard the specified component. Follow local disposal regulations.
- Discard the specified component. Follow local disposal regulations.
-
NOTE: Note the location of the check balls for assembly.
- Remove the lower valve body assembly.
- Discard the specified component. Follow local disposal regulations.
-
NOTE: Remove the valves by tapping the valve body on the palm of the hand to slide the valves out of the bores. It may be necessary to remove the valves and springs using a pick. If it is necessary to use a pick, use extreme caution to prevent damaging the valves or valve bores. If necessary, disassemble parts of the main control valve body in small groups. Take special care when handling the main control components, since they are the most precise and delicate parts of the transmission. Neatly arrange the parts as they are removed to avoid mixing similar pieces.NOTE: Do not stone or polish any valves. If the valves do not move freely, install a new assembly.
Remove the individual valves and springs from the main control valve body and lower valve body by removing the retaining clips. See the Valve Body and Lower Valve Body illustrations at the beginning of this procedure for valve and spring locations. Clean valves, springs, main control valve body and lower valve body.
-
NOTE: Do not stone or polish any valves. If the valves do not move freely during assembly, install a new valve body.
Install the valve body valves, springs and retaining clips in the main control valve body and lower valve body. See the Valve Body and Lower Valve Body illustrations at the beginning of this procedure for valve and spring locations.
-
NOTE: Install the check balls in the correct location as noted during disassembly.
-
- 63 mm (2.48 in) bolts
- 35 mm (1.377 in) bolts
-
- Tighten to 12 Nm (106 lb-in).
-
- 63 mm (2.48 in) bolts
- 35 mm (1.377 in) bolts
-
- Tighten to 12 Nm (106 lb-in).