Powertrain Control Module (PCM): Installation
-
- To install, reverse the removal procedure.
- Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
-
NOTE: This step is only necessary when installing a new component.
Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Programming .Use the General Equipment: Ford Diagnostic Equipment
-
NOTE: This step is only necessary when installing a new component.
Reprogram the Passive Anti-Theft System (PATS). Refer to: Anti-Theft Key Programming - Scan Tool .