Module Configuration and Parameter Chart

WARNING: This page is about a different variant/trim than selected.

The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
ACCM	7C7	No	No	No	None
AWD module	703	No	No	No	None
APIM	7D0	Yes	Yes	No	None
ABS module	760	Yes	Yes	ABS bleed (HEV) Multi-calibration routine (HEV) Inlet valve calibration (HEV) Master cylinder isolation calibration (HEV) IVD initialization EPB apply and release	None
ACM	727	Yes	Yes	No	None
BECM	7E4	Yes	Yes	No	None
BECMB	723	Yes	Yes	No	None
BCM	726	Yes	Yes	Ambient lighting calibration Rear view camera calibration	DRL configuration DRL by autolamps Passive entry/start enable Remote start enable/disable Remote start lighting enable Remote start ignition enable Trim switch inhibit enable/disable
CCM	764	Yes	Yes	No	None
DSP	783	Yes	Yes	No	None
DACMC (Integrated with ACM except for China THX® audio system)	7D5	Yes	Yes	No	None
DC/ DC Converter Control Module (DC/DC) (HEV)	746	No	No	No	None
DDM	740	Yes	Yes	No	None
DSM	744	Yes	Yes	No	None
SCME	776	Yes	Yes	No	None
SCMG	712	Yes	Yes	No	None
FCIM	7A7	Yes	Yes	No	None
GWM	716	Yes	Yes	No	None
GSM	732	No	Yes	No	None
GFM (CD player)	7A1	No	No	No	None
GPSM	701	Yes	Yes	No	None
HCM	734	Yes	Yes	No	None
HUD module	7B2	No	No	No	None
IPC	720	Yes	Yes	No	Automatic engine ignition shutdown (AEIS) with override Driver Beltminder Mid-passenger Beltminder Passenger Beltminder Remote start enable/disable Remote start climate settings driver seat passenger seat rear defrost steering wheel
HSWM	714	Yes	Yes	No	None
IPMA module	706	Yes	Yes	Camera calibration	None
OCSM	765	No	No	OCSM re-zero	None
PAM (integrated with BCM)	736	Yes	Yes	No	None
SCMH	713	Yes	Yes	No	None
PSCM	730	Yes	Yes	No	None
PCM	7E0	No	Yes	No	None
PDM	741	Yes	Yes	No	None
RTM	751	Yes	Yes	No	None
RACM (China only)	774	No	No	No	None
RGTM	775	Yes	Yes	Power luggage compartment lid initialization	None
RCM	737	Yes	Yes	No	None
SODL	7C4	Yes	Yes	No	Blockage enabled Enable/disable configuration
SODR	7C6	Yes	Yes	No	Blockage enabled Enable/disable configuration
SCCM	724	Yes	Yes	No	None
SOBDMC/ TCM (HEV)	7E6	Yes	Yes	No	None
TCU	754	Yes	Yes	No	None
TRCM	711	No	Yes	No	None
VDM	721	Yes	Yes	Suspension height sensor calibration	None