Pinpoint Test Purpose

To verify PSCM C100C is present and provide diagnostics if DTC C100C is currently present and active in the PSCM.

1. O1: VISUAL INSPECTION 
   • Carry out a visual inspection.
     • Check for even tire sizes and pressures as per the manufacturer's specification.
     • Check for uneven tire wear.
     • Check the outer tie rod ends and suspension ball joints for impeded movement.
     • Verify that the steering column shaft rotates freely and is not grounded against other vehicle components.
     • Check the steering gear for correct installation, tight spots and uneven operation.
     • Check the steering and suspension for bent or damaged components.
     • Check the steering and suspension geometry.
   • Has a concern been identified? 

     Yes	No
     REPAIR the concern identified during the visual inspection. CLEAR the DTCs. CARRY OUT the steering angle sensor calibration procedure. REFER to PROGRAMABLE PARAMETERS/STEERING WHEEL POSITION SENSOR CALIBRATION on the scan tool and follow the calibration procedure.	CLEAR the DTCs. CARRY OUT the steering angle sensor calibration procedure. REFER to PROGRAMABLE PARAMETERS/STEERING WHEEL POSITION SENSOR CALIBRATION on the scan tool and follow the calibration procedure.