| C1979:00 |
IWE Solenoid Circuit Failure: No Sub Type Information |
This DTC sets when the TCCM detects there is a possible mechanical fault present with the IWE system based on wheel speed message data. When the DTC is present IWE solenoid output shall continue to operate normally. PERFORM the Four-Wheel Drive (4WD) System Functional Test GO to Pinpoint Test A |
| C1979:11 |
IWE Solenoid Circuit Failure: Circuit Short To Ground |
GO to Pinpoint Test D |
| C1979:12 |
IWE Solenoid Circuit Failure: Circuit Short To Battery |
GO to Pinpoint Test D |
| C1979:13 |
IWE Solenoid Circuit Failure: Circuit Open |
GO to Pinpoint Test D |
| P0562:00 |
System Voltage Low: No Sub Type Information |
GO to Pinpoint Test C |
| P0563:00 |
System Voltage High: No Sub Type Information |
GO to Pinpoint Test C |
| P06B8:00 |
Internal Control Module Non-Volatile Random Access Memory (NVRAM) Error: No Sub Type Information |
GO to Pinpoint Test X |
| P1825:00 |
4-Wheel Drive Clutch Relay Open Circuit: No Sub Type Information |
GO to Pinpoint Test F |
| P1826:00 |
4-Wheel Drive Low Clutch Relay Circuit To Battery: No Sub Type Information |
GO to Pinpoint Test F |
| P1827:00 |
4-Wheel Drive Low Clutch Relay Circuit To Ground: No Sub Type Information |
GO to Pinpoint Test F |
| U0100:00 |
Lost Communication With ECM/PCM "A": No Sub Type Information |
GO to Pinpoint Test G |
| U0101:00 |
Lost Communication With TCM "A": No Sub Type Information |
GO to Pinpoint Test H |
| U0121:00 |
Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub Type Information |
GO to Pinpoint Test K |
| U0138:00 |
Lost Communication with All Terrain Control Module |
GO to Pinpoint Test I |
| U0140:00 |
Lost Communication With Body Control Module (BCM): No Sub Type Information |
GO to Pinpoint Test J |
| U0418:00 |
Invalid Data Received From Brake System Control Module: No Sub Type Information |
GO to Pinpoint Test N |
| U0439:00 |
Invalid Data Received From All Terrain Control Module: No Sub Type Information |
GO to Pinpoint Test O |
| U2300:54 |
Central Configuration: Missing Calibration |
GO to Pinpoint Test P |
| U2300:55 |
Central Configuration: Not Configured |
GO to Pinpoint Test Q |
| U2300:56 |
Central Configuration: Invalid / Incompatible Configuration |
GO to Pinpoint Test R |
| U2300:64 |
Central Configuration: Signal Plausibility Failure |
GO to Pinpoint Test S |
| U3000:04 |
Control Module: System Internal Failure |
GO to Pinpoint Test T |
| U3000:46 |
Control Module: Calibration / Parameter Memory Failure |
GO to Pinpoint Test U |
| U300D:11 |
Ignition Input On/Start: Circuit Short To Ground |
GO to Pinpoint Test B |
| U0140:00 |
Lost Communication With Body Control Module (BCM): No Sub Type Information |
GO to Pinpoint Test L |
| U3000:49 |
Control Module: Internal Electronic Failure |
GO to Pinpoint Test V |
| U2009:9E |
Rotary Encoder: Stuck On |
GO to Pinpoint Test V |
| U2002:9E |
Switch: Stuck On |
GO to Pinpoint Test W |