LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 2023 >> Corsair Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (Module Configuration) >> General Procedures >> Module Programming >> Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module Programming: Check

WARNING: This page is about a different car, the 2022 Lincoln Corsair. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Perform the following pre-checks to make sure module programming completes without errors.
  1. Start the programming session in KOEO.
  2. Make sure the vehicle battery is fully charged or is connected to a battery charger. The battery state of charge should be 12.6 - 13.6 volts during vehicle programming.
  3. NOTE: A good internet connection is necessary.

    Inspect the VCM II or VCMM and cables for damage. Make sure cables remain connected throughout the programming procedure.

  4. Turn off all unnecessary accessories, such as radio, A/C, climate controlled seats, headlamps, interior and demand lamps.
  5. Disconnect any aftermarket accessories, such as remote start, security alarm and power inverter.
  6. For Plug-in hybrid and electric vehicles, disconnect the external charge cord from the charge port.
  7. Disable Microsoft Windows sleep mode, screensaver and hibernation modes.
scientia non olet · About LEMON Manuals