LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1982 >> RX-7 GS, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Ignition System >> MITSUBISHI Electronic Ignition MAZDA Rotary Engine >> Testing >> IGNITOR Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

IGNITOR Check

  1. Remove ignitor from distributor base. Make a circuit as shown in Fig 1 using wire and a test bulb. Use a 12 volt bulb of less than 10 watts.
    Fig 1: Test Lamp Hookup for Checking Ignitor Operation
    G09323515Courtesy of MAZDA MOTORS CORP.

    Bulbs should flash when switch is operated. 

  2. Quickly operate switch "ON" and "OFF", and make sure test lamp flashes. If not, replace ignitor.
scientia non olet · About LEMON Manuals