LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1991 >> 929 Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Removal & Installation >> Fuel System Priming >> Except Navajo
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Except Navajo

  1. On B2200 PFI, B2600i, MPV, MX-6, RX7, 626 and 929, connect jumper wire between terminals of Yellow 2-pin connector. See FUEL PUMP TEST CONNECTOR LOCATION  table.
  2. On Miata, Protege and 323, connect jumper wire between GRN and F/P terminals of diagnostic connector. See Fig 1 . On all models, turn ignition on for about 10 seconds, then turn ignition off. Disconnect jumper wire.
    Fig 1: Diagnostic Connector Terminal ID (Miata, Protege & 323)
    G91I17838Courtesy of MAZDA MOTORS CORP.
    FUEL PUMP TEST CONNECTOR LOCATION

    Application Location
    B2200 PFI & B2600i In Right Rear Corner Of Engine Compartment
    MPV & 929 In Left Front Corner Of Engine Compartment
    MX-6 & 626 Near Left Strut Tower
    RX7 In Right Front Corner Of Engine Compartment
scientia non olet · About LEMON Manuals