Section 2 (Engine Controls - Basic Testing): Introduction
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1990 Mazda RX-7, 1990 Mazda Protege, 1990 Mazda MX-6, 1990 Mazda MX-5 Miata, and 1990 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
The following diagnostic steps will help prevent overlooking a simple problem. This is also where to begin diagnosis for a no start condition.
The first step in diagnosing any driveability problem is verifying the customer's complaint with a test drive under the conditions the problem reportedly occurred.
Before entering self-diagnostics, perform a careful and complete visual inspection. Most engine control problems result from mechanical breakdowns, poor electrical connections or damaged/misrouted vacuum hoses. Before condemning the computerized system, perform each test listed in this article.
NOTE:
Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless specifically stated differently in test procedure.