Checking ICM Control

If voltage was less than described in CHECK C1, C2 & C3 AT COIL PACK (RUNNING) or CHECK C1, C2 & C3 AT COIL PACK (CRANKING), replace coil pack. If voltage was greater than described, check circuits between coil pack and ICM module for opens or shorts. If circuits okay, replace ICM. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes.

NOTE: Capacitor and resistors shown in schematic in Figure are part of test harness and are used for test specifications. They are not part of vehicle wiring.