Ignition Timing

WARNING: This page is about a different car, the 1994 Mazda B3000 and 1994 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before adjusting ignition timing, warm engine to normal operating temperature. Turn off all accessories. Place transmission in Neutral (M/T) or Park (A/T). Ensure idle speed is correct. See IDLE SPEED under IDLE SPEED & MIXTURE. If timing is not within specification, loosen distributor or Crank Angle Sensor (CAS) lock bolt. Rotate distributor or CAS until timing marks are aligned. Tighten lock bolt.

Fig 1: Locating Ignition Timing Marks (Typical)

Courtesy of MAZDA MOTORS CORP.

IGNITION TIMING SPECIFICATIONS

Application

Man. Trans.

⁽¹⁾ Auto. Trans.

B2300

8-12 @ 475-575

B3000 ⁽²⁾

8-12 @ 475-575

⁽¹⁾	Place automatic transmission in Park.

⁽²⁾	Connect jumper wire between Green test connector and ground.