Control Switch

Disconnect control switch 6-pin connector. Disconnect 2-pin connector at each seat motor. Check continuity between specified terminal of control switch connector and specified terminal of motor connector with control switch in specified position. See CONTROL SWITCH & MOTOR CONTINUITY TEST . See Fig 1 -Fig 4 . If continuity does not exist between terminals as specified, replace control switch or motor.

CONTROL SWITCH & MOTOR CONTINUITY TEST

Control Position		Control Switch & Motor Terminals
Front Lift Switch
Down		"A" & "F"; "B" & "E"
Up		"A" & "E"; "B" & "F"
Rear Lift Switch
Down		"A" & "H"; "B" & "G"
Up		"A" & "G"; "B" & "H"
Slide Switch
Backward		"A" & "D"; "B" & "C"
Forward		"A" & "C"; "B" & "D"

Fig 1: Control Switch & Motor Conn. Terminal ID - Control Switch

Courtesy of MAZDA MOTORS CORP.

Fig 2: Control Switch & Motor Conn. Terminal ID - Slide Motor

Courtesy of MAZDA MOTORS CORP.

Fig 3: Control Switch & Motor Conn. Terminal ID - Front Lift Motor

Courtesy of MAZDA MOTORS CORP.

Fig 4: Control Switch & Motor Conn. Terminal ID - Rear Lift Motor

Courtesy of MAZDA MOTORS CORP.