Abs Control Module Test

WARNING: This page is about a different car, the 1996 Mazda Protege and 1995 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

ABS Control Module (CM) is located behind left side of instrument panel. Unless indicated otherwise, test with ignition on and ABS control module connector connected. Measure voltage between ground and applicable terminal of ABS CM connector. If voltage is not as specified, check appropriate component listed under INSPECTION POINT. See Fig 1 and Fig 2 . If components are okay, replace ABS CM.

Fig 1: Testing ABS Control Module (1 Of 2)

Courtesy of MAZDA MOTORS CORP.

Fig 2: Testing ABS Control Module (2 Of 2)

Courtesy of MAZDA MOTORS CORP.