Control Module: Service and Repair

Replacement
1. Disconnect the negative battery cable.
2. Remove the front side trim (passenger side).
3. Remove the engine control module.
4. Remove the nuts shown in the figure and disconnect the transmission control module connectors.
5. Install the new transmission control module.

Tightening torque:
7.9-10.7 N m (70-95 in.lb.)

6. Connect the transmission control module connectors.
7. Install the engine control module.

Tightening torque:
7.9-10.7 N m (70-95 in.lb.)

8. Install the front side trim (passenger side).
9. Connect the negative battery cable.