Hydraulic System Bleeding
- Using Clutch Disconnect Tool (T88T-70522-A ), disconnect hydraulic line at transmission. See Fig 1 . Clean reservoir cap area. Fill reservoir with DOT 3 brake fluid. Maintain fluid level in reservoir during bleeding procedure.
- Using small screwdriver, press and hold internal mechanism of male coupler to open valve. While holding valve open, have an assistant slowly press and hold clutch pedal to floor.
- Remove screwdriver to allow valve to close. Release clutch pedal. Refill reservoir.
- Repeat steps 2) and 3). Install reservoir cap. Reconnect hydraulic line. Tug hydraulic line lightly to verify secure connection.
- As rapidly as possible, operate clutch pedal for full 5-10 strokes. Wait 3 minutes. Repeat this step at least 3 more times.
- Loosen bleed screw, located next to release cylinder connection. Have an assistant press and hold clutch pedal. Tighten bleed screw. Release pedal. Refill reservoir. Check clutch operation.