With Automatic Transaxle

Transaxle Range Switch Replacement
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh air duct, and air cleaner assembly.
3. Disconnect the TR switch connector.




4. Remove the TR switch.




5. Shift the transaxle into N position.
6. Install the TR switch on the manual lever shaft.
7. Hand tighten the two mounting bolts.
8. Use the SST to align the switch on the shaft and case.
9. Tighten the two mounting bolts.

Tightening torque: 9.8 Nm (86.8 in.lbs.)