EGR Monitor Repair Verification Drive Mode

WARNING: This page is about a different car, the 1997 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

Refer to and the Preparation before initiating the following repair verification steps.
Start the engine and drive the vehicle for 6 minutes.
1. Drive in stop-and-go traffic for 5 minutes with at least two idle periods.
2. Accelerate to 72 km/h (45 mph). Maintain speed for 1 minute.
With the ignition key ON (vehicle at idle or engine off), check for Retrieve/Clear Continuous DTCs.