With Automatic Transaxle

REMOVAL

NOTE: The engine coolant temperature sensor is at the rear of the engine.




1. Disconnect the engine coolant temperature sensor connector.
2. Remove the engine coolant temperature sensor.

INSPECTION




1. Place the sensor in water with a thermometer and heat the water gradually.
2. Measure the resistance of the sensor.




3. It not as specified, replace the engine coolant temperature sensor.

INSTALLATION




1. Install a new washer and the engine coolant temperature sensor.

Tightening torque: 15.7-23.5 Nm (11.6-17.3 ft.lbs.)

2. Connect the engine coolant temperature sensor connector.
3. Start the engine and check for coolant leakage.