Abs Control Module

ABS CM is located behind left side of instrument panel. Unless indicated otherwise, test with ignition switch turned to ON position and ABS CM connector connected. Measure voltage between chassis ground and applicable terminal of ABS CM connector. If voltage is not as specified, check appropriate component listed under INSPECTION POINT. See Fig 1-Fig 4 . If components are okay, replace ABS CM.

Fig 1: Testing ABS Control Module With Traction Control System (1 Of 2)

Courtesy of MAZDA MOTORS CORP.

Fig 2: Testing ABS Control Module With Traction Control System (2 Of 2)

Courtesy of MAZDA MOTORS CORP.

Fig 3: Testing ABS Control Module Without Traction Control System (1 Of 2)

Courtesy of MAZDA MOTORS CORP.

Fig 4: Testing ABS Control Module Without Traction Control System (2 Of 2)

Courtesy of MAZDA MOTORS CORP.