Using the SST (NGS Tester)

PCM INSPECTION USING THE SST (NGS TESTER)

NOTE: PIDs for the following parts are not available on this model. Go to the appropriate part inspection.

1. ECT sensor (Water temperature sender unit) (Refer to ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION.)
Testing and Inspection

2. CMP sensor (Refer to CAMSHAFT POSITION (CMP) SENSOR INSPECTION.)
Testing and Inspection

3. Main relay (Refer to MAIN RELAY INSPECTION.)
Testing and Inspection

1. Connect the NGS tester to the DLC-2. Refer to On-Board Diagnostic Test.)


2. Turn the ignition switch on.
3. Select the "PID/DATA MONITOR AND RECORD" function on the NGS display and press TRIGGER. Refer to On-Board Diagnostic Test, PID/DATA monitor and record procedure.)

4. Select the appropriate PID on the NGS display and press START.

5. Measure the PID value.
- If PID value is not within the specification, follow the instruction in Action column.

NOTE:
- Perform the SIMULATION TEST for the output device after PID/DATA measurement is completed.




- The simulation items that are used in the system inspection are as given in the table.

PART 1 OF 6:

PART 2 OF 6:

PART 3 OF 6:

PART 4 OF 6:

PART 5 OF 6:

PART 6 OF 6:

PID/DATA MONITOR TABLE (REFERENCE)

*1 : ATX only
*2 : MTX only
*3 : Except federal emission regulation applicable MTX models
*4 : California emission regulation applicable model