LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2000 >> MPV DX >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Cruise Control System) >> Component Tests >> Cruise Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Cruise Control Module

WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate cruise control module below instrument cluster. Leave cruise control module harness connector attached unless otherwise specified.
  2. Using DVOM, backprobe specified terminals of cruise control module harness connector while performing appropriate test condition. See CRUISE CONTROL MODULE PIN VOLTAGE  table. See Fig 1 .
  3. If voltage measurements or continuity measurements are not as specified, check related components and wiring. See WIRING DIAGRAMS  . If related components and wiring are okay, but system is still not functioning properly, replace cruise control module.
CRUISE CONTROL MODULE PIN VOLTAGE

Terminal (Signal)/Test Condition Value
A (Actuator Control)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Less Than 1 Volt
B (Actuator Control)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Less Than 1 Volt
C (Actuator Control)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Less Than 1 Volt
D (Indicator Light Output)
Ignition On Battery Voltage
Ignition LOCK Or ACC Less Than 1 Volt
E (IG1)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Less Than 1 Volt
G (PCM O/D Off)
Ignition On Battery Voltage
Ignition LOCK Or ACC Less Than 1 Volt
H (Cruise Brake Switch)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Less Than 1 Volt
I (Data Link Connector) (1)
J (Transmission Range Switch)
Ign. On, Main Sw. On, Not In Park Or Neutral Battery Voltage
Ign. On, Main Sw. Off, In Park Or Neutral Less Than 1 Volt
K (Brake Cruise Switch
Brake Pedal Depressed Battery Voltage
Brake Pedal Released Less Than 1 Volt
L (Cruise Control Switch Position)
Ign. On, Main Sw. On, SET/COAST Sw. Depressed 2.5 Volts
Ign. On, Main Sw. On, RESUME/ACCEL Sw. Depressed 1.2 Volts
Ign. On, Main Sw. On, CANCEL Sw. Depressed 3.5 Volts
Ign On, Cruise Main Held On 5.4 Volts
M (Brakelight Switch)
Brake Pedal Released Battery Voltage
Brake Pedal Depressed Less Than 1 Volt
N (Vehicle Speed Sensor)
Ign. On, Cruise Control Main Switch Held On, Front Tires Rotating Alternating 0-5 Volts
O (Cruise Control Main Switch Input)
Ign. On, Main Sw. Off, Battery Voltage
Ign. On, Main Sw. On Less Than 1 Volt
P (Ground) At All Times (2) Continuity To Ground
(1) Information is not available from manufacturer.
(2) Turn ignition switch to LOCK position. Disconnect cruise control module harness connector. Measure resistance between ground and appropriate terminal.
Fig 1: Identifying Cruise Control Module Connector Terminals
G96D06961Courtesy of MAZDA MOTORS CORP.