Possible Causes

Poor connection of any SAS control module connector, malfunction of any SAS control module connector or SAS control module malfunction.

1. Check SAS control module connectors for proper connection
   
   Turn ignition switch to LOCK position. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Access SAS connector module and ensure connectors are properly connected. If connectors are properly connected, go to next step. If connectors are not connected properly, reconnect connectors.
2. Inspect SAS control module connectors for damage
   
   Remove steering column cover and disconnect clockspring connector. Remove glove compartment and disconnect passenger-side air bag module connectors. On models equipped with side air bags, disconnect right and left side air bag module connectors. On models equipped with side curtain air bags, disconnect right and left side curtain air bag module connectors. On models equipped with seat belt pretensioners, remove right and left lower B-pillar trims and disconnect seat belt pretensioner connectors. On all models, disconnect all SAS control module connectors. Inspect SAS control module connector connection detector bars for damage. If detector bars are damaged, replace wiring harness. If detector bars are not damaged and performing present malfunction diagnosis, replace SAS control module. See SAS CONTROL MODULE  under REMOVAL & INSTALLATION. If detector bars are not damaged and performing past malfunction diagnosis, test is complete.