Selector Cable Installation Note (FN4A-EL automatic transaxle models)

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Install the selector cable to the selector lever securely.
Install the selector cable to the bracket securely.
NOTE:
- Steps 3 and 4 are for the selector cable replacement only.
Verify that the selector lever is in the P position.

Fig 1: Installing Selector Cable To Bracket
Courtesy of MAZDA MOTORS CORP.
Lock the lock piece of the selector cable (selector lever side) in the order shown in Fig 2.
Verify that the manual shaft is in the P position.

Fig 2: Locking Lock Piece Of Selector Cable (Selector Lever Side) In Proper Order
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- Bending the selector cable in the manner shown in the figure will damage the cable and it may become loose when shifted. When installing the selector cable, hold it straight.
Fig 3: Locating Critical Bending Position In Selector Cable
Courtesy of MAZDA MOTORS CORP.
Install the clip as shown in Fig 4.

Fig 4: Installing Clip On The Selector Cable
Courtesy of MAZDA MOTORS CORP.
NOTE:
- Install the selector lever to the manual shaft lever with the clip side of the selector cable end facing the front of the vehicle.
Fig 5: Installing Selector Lever To Manual Shaft Lever In Proper Manner
Courtesy of MAZDA MOTORS CORP.
Install the selector lever to the manual shaft lever so that no load acts on the selector cable.
Confirm that the tip of the manual shaft lever projects out of the end of the selector cable.
Securely install the selector cable to the selector cable bracket.