No. 2 Additional Key Registration Procedure (Using WDS Or Equivalent) Conditions

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Customer has only one valid key. Or customer has no valid keys. (Can also be performed even if there are two or more valid keys)

NOTE:

A maximum of eight keys can be registered for any one vehicle. If key registration is not successful and DTC 15 appears even though the procedure was performed properly, use the PID/data monitor function of the WDS or equivalent and verify the number of keys that have been registered.
If eight keys have already been registered, and it is necessary to register other keys, the previously registered key ID numbers must first be cleared. Perform key ID number clearing according to "NO. 3 KEY REPLACEMENT PROCEDURE (CLEARING PREVIOUSLY REGISTERED KEY ID NUMBERS, KEY REGISTRATION)" .

Procedure

Have one key (key 1) ready for registration.
Using key 1, turn the ignition switch to the ON position.
NOTE:
- Although the security light flashes and DTC 15 is displayed, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
Connect the WDS or equivalent to the DLC-2.
Select "Body/Security/PATS function" from the screen menu of the WDS or equivalent.
Perform security access as indicated on the WDS or equivalent screen. (See NO. 6 SECURITY ACCESS PROCEDURE .)
Select "Program Additional ignition Key" from the screen menu of the WDS or equivalent.
NOTE:
- After selecting this menu. "Successful" appears on the WDS or equivalent screen. When this occurs, registration is completed for the key turning the ignition switch to the ON position.
- If the necessary number of keys have been registered, the additional key registration procedure is completed with this step. Go to Step 10.
- If additional keys need to be registered, go to the next step.
After verifying that the PATS function menu is displayed again on the WDS or equivalent screen, turn the ignition switch to the LOCK position and remove key 1.
Using an additional key requiring registration, turn the ignition switch to the ON position.
Return to Step 6.
After verifying that the PATS function menu is displayed again on the WDS or equivalent screen, select "Exit" to complete the WDS or equivalent function.
After Step 10. wait 10 s or more and turn the ignition switch to the LOCK position.