Harness Connector Installation Note
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Improper connection of the wiring harness connectors for primary injectors 1 and 2 may occur because the connectors on the front and rear rotor sides have the same shape. When connecting the wiring harnesses and injectors, verify the colored identification tape affixed on the wiring harness side and the injector positions, and then connect the wiring harness connectors to the proper injectors. If the colored tape has peeled off or was never affixed, verify injector connection according to the colors of the wires.
- Verify the colors of the identification tape on the wiring harness connectors and the injector connections according to the following table.
- If there is no colored tape, identify injector connection according to the colors of the wires and connect the wiring harness connectors.
Identification tape color
IDENTIFICATION TAPE COLOR REFERENCEHarness Connector Identification tape color FP1 White RP1 Orange FP2 Yellow RP2 Green FS - RS -