Transmission Position Sensor/Switch: Adjustments

TRANSMISSION RANGE (TR) SWITCH ADJUSTMENT
1. Disconnect the negative battery cable.
2. Remove the selector rod from manual shaft lever.
3. Rotate the manual shaft to the N position.
4. Loosen the TR switch mounting bolt.





5. Align the cut groove in the switch with the neutral reference line.
6. Tighten the TR switch mounting bolt.
Tightening torque
4.0 - 6.8 Nm (40 - 70 kgf.cm, 35 - 60 inch lbs.)
7. Install selector rod to the manual shaft lever.
8. Connect the negative battery cable.
9. Inspect the operation of the TR switch.