Crankshaft Position Sensor: Service and Repair

1. Disconnect the crankshaft position sensor connector.
2. Remove the undercover.
3. Remove the crankshaft position sensor installation bolt.
4. Install in the reverse order of removal.

Tightening torque
7.9 - 10.7 N.m {80 - 110 kgf.cm, 69.5 - 95.4 in.lbf}

5. Reconnect the crankshaft position sensor connector.

NOTE: Do not forcefully pull the wiring harness of the crankshaft position sensor.

6. Adjust the air gap.