LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2000 >> Millenia Base, 2.5 >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Self-Diagnostic System >> Condition Detection Mode >> Using Cruise Indicator Light
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using Cruise Indicator Light

NOTE: If RESUME/ACCEL switch is malfunctioning, cruise indicator light will not provide a correct indication when cruise system is inspected. Use NGS tester procedure.
  1. Turn ignition switch to RUN position. Turn cruise control main switch on. Ensure cruise indicator light illuminates. If cruise indicator light does not illuminate, service before continuing.
  2. Press and hold RESUME/ACCEL switch for at least 3 seconds. Cruise indicator light will illuminate for 3 seconds, and then go out for 2 seconds. Cruise indicator light will flash condition detection mode DTCs (if set). A long pause separates DTCs (output patterns). On 2-digit DTCs, a short pause separates each digit of DTC (for example: 1 long flash, pause, 5 short flashes indicates DTC 15). If no DTCs are set, light will not flash. If no DTCs exist, go to step  9 . If any DTCs exist, go to next step.
  3. If DTC 01 does not exist, go to next step. If DTC 01 exists, check actuator circuit. See ACTUATOR CIRCUIT  under CIRCUIT TESTS.
  4. If DTC 05 does not exist, go to next step. If DTC 05 exists, check brake switch circuit. See BRAKE SWITCH CIRCUIT  under CIRCUIT TESTS.
  5. If DTC 07 does not exist, go to next step. If DTC 07 exists, check brake switch circuit. See BRAKE SWITCH CIRCUIT  under CIRCUIT TESTS.
  6. If DTC 11 does not exist, go to next step. If DTC 11 exists, check cruise control switch circuit. See CRUISE CONTROL SWITCH CIRCUIT  under CIRCUIT TESTS.
  7. If DTC 12 does not exist, go to next step. If DTC 12 exists, check cruise control switch circuit. See CRUISE CONTROL SWITCH CIRCUIT  under CIRCUIT TESTS.
  8. If DTC 15 exists, replace cruise control module. If DTC 15 does not exist, no cruise control module DTCs exist at this time. Go to next step.
  9. To cancel condition detection mode, drive vehicle at a speed greater than 10 MPH or turn cruise control main switch off. Ensure cruise indicator light goes out.
scientia non olet · About LEMON Manuals