Airflow Mode Main Link Installation Note

WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

If any grease other than the specified grease is applied to the links, abnormal noise will occur or the links will not properly operate. Therefore, do not apply any grease to the links.

Push and hold each airflow mode sub link in the direction of the arrow as shown in Fig 1 .

Fig 1: Positioning Airflow Mode Sub Links
Courtesy of MAZDA MOTORS CORP.
Set the airflow mode main link to the heater unit as shown in Fig 2 .

Fig 2: Installing Airflow Mode Main Link To Heater Unit
Courtesy of MAZDA MOTORS CORP.
Press the airflow mode main link lightly and rotate it in the direction of the arrow, then set the projections of each airflow mode sub link into the grooves of the airflow mode main link as shown in Fig 3 .

Fig 3: Setting Sub Links Projections Into Grooves Of Airflow Mode Main Link
Courtesy of MAZDA MOTORS CORP.
Rotate airflow mode main link and verify that each mode is accessed properly.