Input/Output Check Mode
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
DTCs must be accessed in numerical order. If a lower number DTC needs to be accessed, discontinue test and start over.
- Turn ignition to LOCK position. Disconnect negative battery cable. After more than 30 seconds, reconnect negative battery cable. Cycle ignition switch to ON position, then LOCK position, 3 times. Turn ignition switch to ON position. Push trip reset button 3 times.
- Push trip reset button and select appropriate DTC. See DTC DEFINITIONS table. Inspect DTC by following procedures under appropriate diagnostic test. If two or more DTCs are being diagnosed, diagnose DTCs 22 and 24 first, followed in order by DTCs 10, 11, 12, 13, 16, 23, 25 and 26. To cancel input/output check mode, turn ignition switch to LOCK, then ON position. If no DTCs are present, diagnose by symptom. See SYMPTOM DIAGNOSIS table.