LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2001 >> Protege ES, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Component Tests >> Cruise Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Cruise Control Module

  1. Locate cruise control module behind right kick panel. Leave cruise control module harness connector attached.
  2. Using DVOM, backprobe specified terminals of cruise control module harness connector while performing appropriate test condition. See CRUISE CONTROL MODULE PIN VOLTAGE  table. See Fig 1 .
  3. If voltage measurements or continuity measurements are not as specified, check related components and wiring. See WIRING DIAGRAMS  . If related components and wiring are okay, but system is still not functioning properly, replace cruise control module.
CRUISE CONTROL MODULE PIN VOLTAGE

Terminal (Signal)/Test Condition Value
A (Actuator Control)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Zero Volts
B (Actuator Control)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Zero Volts
C (Actuator Control)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Zero Volts
D (Indicator Light Output)
Ignition On Battery Voltage
Ignition LOCK Or ACC Zero Volts
E (IG1)
Ignition On Battery Voltage
Ignition LOCK Or ACC Zero Volts
G (PCM O/D Off)
Ignition On Battery Voltage
Ignition LOCK Or ACC Zero Volts
H (Cruise Brake Switch)
Ignition On, Main Switch On Battery Voltage
Ignition On, Main Switch Off Zero Volts
I (Data Link Connector) (1)
J (Clutch Switch - M/T)
Ign. On, Main Sw. On, Clutch Pedal Released Battery Voltage
Ign. On, Main Sw. Off, Clutch Pedal Depressed Zero Volts
J (Transmission Range Switch - A/T)
Ign. On, Main Sw. On, Not In Park Or Neutral Battery Voltage
Ign. On, Main Sw. Off, In Park Or Neutral Zero Volts
K (Brake Cruise Switch)
Brake Pedal Depressed Battery Voltage
Brake Pedal Released Zero Volts
L (Cruise Control Switch Position)
Ign. On, Main Sw. On, SET/COAST Sw. Depressed 1.5 Volts
Ign. On, Main Sw. On, RESUME/ACCEL Sw. Depressed .5 Volts
Ign. On, Main Sw. On, CANCEL Sw. Depressed 3 Volts
Ign On, Other 5 Volts
M (Brakelight Switch)
Brake Pedal Depressed Battery Voltage
Brake Pedal Released Zero Volts
N (Vehicle Speed Sensor)
Ign. On, Rear Tires Rotating Alternating 0-5 Volts
Ign On, Rear Tires Not Rotating Zero Or 5 Volts
O (Cruise Control Main Switch Input)
Ign. On, Main Sw. Off, Battery Voltage
Ign. On, Main Sw. On Zero Volts
P (Ground) At All Times (2) Continuity To Ground
(1) Information is not available from manufacturer.
(2) Turn ignition switch to LOCK position. Disconnect cruise control module harness connector. Measure resistance between ground and appropriate terminal.
Fig 1: Identifying Cruise Control Module Connector Terminals
G96D06961Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals