Ignition Switch Removal/Installation

Disconnect the negative battery cable.
Detach the hood lock release handle and position aside.
Remove the lower instrument panel steering column cover and instrument panel steering column opening cover reinforcement. See Figure .

NOTE: The ignition should be in the OFF position.

Fig 1: Removing/Installing Ignition Switch

Courtesy of MAZDA MOTORS CORP.

Loosen the bolt and disconnect the electrical connector.
1. Remove the two screws.
2. Remove the ignition switch.
Install in reverse order of removal.
1. Tightening Torque
  1. 5.3-7.2 N.m {54-73 kgf.cm, 47-64 in.lbf}