Camber Adjustment

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Adjustable value is 30'.

Jack up the vehicle and remove the wheel and tire.
Remove the indicated bolt and replace it with the adjusting bolt and washer.

Fig 1: Removing Indicated Bolt
Courtesy of MAZDA MOTORS CORP.
Adjust in the following procedures.
- In case of adjusting to + (positive) side, install the adjusting bolt and washer so that the projection of the washer faces inside (shock absorber side) as shown.
  
  Fig 2: Adjusting Camber To Positive Side
  Courtesy of MAZDA MOTORS CORP.
- In case of adjusting to - (negative) side, install the adjusting bolt and washer so that the projection of the washer faces outside (steering knuckle side) as shown.
  
  Fig 3: Adjusting Camber To Negative Side
  Courtesy of MAZDA MOTORS CORP.
Tighten the nut to the specified torque.
Tightening torque
1. 102.9-122.5 N.m {10.50-12.49 kgf.m, 75.90-90.35 ft.lbf}
Install the wheel and tire, then jack down the vehicle.
Shake the vehicle to settle the suspension.
Inspect the camber and readjust it if necessary.