LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2003 >> MPV ES >> Repair and Diagnosis >> External Pages >> Different car >> Section 294 (Control System (Communication Network)) >> Key Programming Switch State Control - WDS
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Key Programming Switch State Control - WDS

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The spare key programming switch is a WDS programmable switch which provides the capability to enable/disable the customer spare key programming procedure. Refer to the Owner Literature spare key programming procedure or KEY PROGRAMMING USING TWO PROGRAMMED KEYS  . This programmable switch is provided as a convenience for customers who may not want the spare key programming procedure available to the vehicle driver.
NOTE:
  • This procedure was performed using WDS B18 software. Later software versions may have a slightly different screen order or content.
  1. Connect WDS DLC cable to vehicle's DLC connector (lower portion of dash in front of driver).
  2. Press "16 PIN", All except those below". Press tick.
  3. Screen shows cable hookup. Turn ignition switch to ON. Press tick.
  4. Screen shows WDS communicating with PCM "progress bar" and "operation in progress".
  5. Wait until WDS finishes collection of PCM information (hard drive light quits flashing). Then the "Vehicle Specification" screen appears with VIN # information. It asks you "Is this correct?" Press "Yes" if information is correct.
  6. Screen appears to fill out R.O. information and mileage. Fill out the information (or skip this). Press tick.
  7. Screen now returns to the "Vehicle Specification Screen".
  8. Now press the "tools" tab on the top, then press "Data Logger". Press tick.
  9. Press "Body", "Security" and then "Passive Anti-Theft System". Press tick.
  10. Press "SPAREKEY". Press tick.
  11. Screen will show the spare key programming switch state.
    • ENABLE = Spare key programming procedure is accessible.
    • DISABLE = Spare key programming procedure is not accessible.
    NOTE:
    • The default setting on delivery of all new vehicles is ENABLED.
  12. To change SPARE KEY PROGRAMMING SWITCH STATE, refer to ANTI-THEFT SECURITY ACCESS - NGS  .
scientia non olet · About LEMON Manuals