Cannot Pull Key Out Of Ignition Switch (05-006/06)

Publication date: 1970-01-01
Reference number: 05-006/06

CANNOT PULL KEY OUT OF IGNITION SWITCH

TECHNICAL SERVICE BULLETIN

Reference Number(s): 05-006/06

MAZDA:

2002-2006 MPV

APPLICABLE MODEL(S)/VINS

2002 -2006 MPV

DESCRIPTION

On some vehicles, the ignition key cannot be pulled out of the ignition switch after shifting the selector lever into P-range. This occurs from someone applying excessive force to the selector lever. The guide plate moves out of position causing poor contact in the P-range switch.

Customers having this concern should have their vehicle repaired using the following repair procedure.

REPAIR PROCEDURE

Verify customer concern.
Replace the Change Control (gear selector lever) according to the Workshop Manual (section 05-18 P POSITION SWITCH (BUILT-IN SELECTOR LEVER) INSPECTION).
Verify repair.

PART(S) INFORMATION

Part Number	Description	Qty.
LD47-46-10XB	Change Control (gear selector lever)	1

WARRANTY INFORMATION

NOTE:

This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair. Refer to the Warranty Wizard for warranty term information.

Additional diagnostic time cannot be claimed for this repair.

WARRANTY INFORMATION CHART

Warranty Type	A
Symptom Code	66
Damage Code	9W
Part Number Main Cause	LD47-46-10XB
Quantity	1
Operation Number / Labor Hours:	XXB348RX / 0.7 Hrs.