Cruise Control Module: Testing and Inspection

CRUISE CONTROL MODULE INSPECTION

1. Remove the lower panel.
2. Remove the key interlock unit. (See KEY INTERLOCK UNIT REMOVAL/INSTALLATION.)
3. Remove the cruise control module with the connector connected.

Terminal Voltage Table (Reference) - Terminal A:

Terminal Voltage Table (Reference) - Terminal (B - I):

Terminal Voltage Table (Reference) - Terminal (J - T):

4. Measure the voltage at the cruise control module terminals as indicated.
5. Disconnect the cruise control module connector before inspecting for continuity at terminal T.
- If not as specified, inspect the parts listed under "Action."
- If the parts and wiring harnesses are okay but the system still does not work properly, replace the cruise control module.