Pressure Feedback Exhaust Sensor: Service and Repair

DIFFERENTIAL PRESSURE FEEDBACK EXHAUST GAS RECIRCULATION (EGR) SYSTEM - SENSOR

Removal and Installation

1. Disconnect the battery ground cable. Refer to BATTERY DISCONNECT.

NOTE: The 3.0L (4V) engine is shown, the 2.0L Zetec engine is similar.




2. Remove the differential pressure feedback EGR sensor.
1. Disconnect the electrical connector.
2. Carefully remove the differential pressure feedback EGR sensor by sliding up and off the EGR tube.

3. To install, reverse the removal procedure.