Power Window Main Switch Inspection

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Remove the power window main switch. (See POWER WINDOW MAIN SWITCH REMOVAL/INSTALLATION .)
When inspecting the passenger's side and the rear, turn the power-cut switch to ON.
Inspect for continuity between the power window main switch terminals using an ohmmeter.
- If not as specified, replace the power window main switch.
Fig 1: Inspecting For Continuity Between Power Window Main Switch Terminals
Courtesy of MAZDA MOTORS CORP.

Fig 2: Switch Position - Power Window Main Switch Terminals - Driver's Side
Courtesy of MAZDA MOTORS CORP.

Fig 3: Switch Position - Power Window Main Switch Terminals - Passenger's Side
Courtesy of MAZDA MOTORS CORP.

Fig 4: Switch Position - Power Window Main Switch Terminals - Rear Left
Courtesy of MAZDA MOTORS CORP.

Fig 5: Switch Position - Power Window Main Switch Terminals - Rear Right
Courtesy of MAZDA MOTORS CORP.

Fig 6: Switch Position - Power Window Main Switch Terminals - Power-Cut Switch
Courtesy of MAZDA MOTORS CORP.