LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2004 >> 3 s, 4D Sedan, Standard >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System] >> After Repair Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

After Repair Procedure

  1. Connect the WDS or equivalent to the DLC-2.
  2. Cycle the ignition switch off, then to the ON position (Engine off).
  3. Record the DTC if retrieved.
  4. Clear all diagnostic data using the WDS or equivalent.
    Fig 1: Identifying DLC-2 Connector Location
    G00974368Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals