When Customer Has Brought Two Or More Valid Keys For Old Steering Lock

Fig 1: Steering Lock Replacement For System Reprogramming

Courtesy of MAZDA MOTORS CORP.

NOTE:

• When replacing the steering lock, the coil and keys should be placed as a set.
• If no specific time interval is given, each step should be performed within 30 seconds  of the previous step.

1. Remove old steering lock.
2. Connect new steering lock to ignition switch connector.
3. Connect old steering lock to coil connector as shown in figure.
4. Insert key 1 into old steering lock.
5. Insert key 3 into new steering lock and turn to ON position then back to LOCK position five times  . The key should not remain at ON position or LOCK position for more than 1 second  .
   1. Turn key 3 back to ON position. Observe illumination of security light in instrument cluster.
   2. Turn key 3 to LOCK position. Observe security light goes out.
NOTE:
• Operate next two steps within 30 seconds  of step  2.
6. Remove key 1 from old steering lock and insert key 2 into old steering lock.
7. Using key 3 of new steering lock, start engine. Observe that security light illuminates (for 1-2 seconds  ) and engine continues to run.
   1. Turn key 3 to LOCK position.
NOTE:
• Operate next two steps within 30 seconds of Step  1.
8. Disconnect coil connector from old steering lock, and reconnect coil connector to new steering lock.
9. Using key 3 of new steering lock, start engine. Observe that security light illuminates (for 1-2 seconds  ) and engine continues to run.
   1. Turn key 3 to LOCK position and remove from steering lock.
10. Repeat Step  9 with key 4.
11. Repeat Step  9 with key 5.
12. Wait for 30 seconds  to quit program mode.
13. Install new steering lock.