Power Door Lock Switch: Service and Repair

DOOR LOCK SWITCH REMOVAL/INSTALLATION

LH

1. Remove the power window main switch.

NOTE: The power door lock switch and the power window main switch are integrated.

2. Install in the reverse order of removal.

RH




1. Disconnect the negative battery cable.
2. Using a flathead screwdriver wrapped with protective tape, pry up the rear of the switch panel and detach the clip.
3. Remove the switch panel from the front door trim keeping the tab from catching.
4. Disconnect the power door lock switch connector and the power window subswitch connector.




5. Remove the screws, then remove the power door lock switch.
6. Install in the reverse order of removal.